Recent content by blazinjames

i pulled the axle. there seems to be alot of play in the side gear? i think that is what the drive axle goes into???

the noise is coming from where the axles go into the transaxle. and there is a bit of play in the axle

so my girlfriends mom 06 Chevy colbalt has a clunking noise.if you driving and go over a bump, or bump the brakes you notice it. so I jack it up. checked all the suspension and steering compenents could find anything. then when moving the wheel back and forth noticed a clunk coming from the...

hey everyone I just have a couple questions. I have a 1991 Eagle 2000gtx that will not start. turns over but doesnt want to start. I replaced spark plugs, leads distributor cap and rotor, there is a strong spark. ive checked engine compression and it is good in all cylinders. there is NO where...

I know there are alot of adds on towing with lifts but I would like some input specifc for me. Im going to be buying a 15foot fiberglass boat with a 70hp engine on it that I would like to tow behind my 1995 Jeep XJ I currently have a 4in lift on the jeep, add-a-leaf and 2in drop shackles. Im...

is this the currie steerign system you have? http://www.currieenterprises.com/cestore/Product.aspx?id=1219

Im looking for overall better steering on hwy or off road. Ive never had any major problems with stock XJ steering but again I have owned a stock XJ for a few years and this is my first time having a raised XJ.

well im currently lifted 4in but may go a bit higher in the future. not sure If I want to go UTK or OTK. I have a rubicon express adjustable track bar and sway bar disconnects so I dont really want to have to change those around so I was thinking UTK.

Im thinking about upgrading my steering to the inverted T setup with Chevy 1 ton tie-rods and have a couple questions. besides the benefit of having stronger components that will stand up to harder abuse are they any other benefits to the upgrade? can you feel a difference in the actual...

never mind i read it and it has the numbers for stock control arm mounts

would that be accurate if you dont have the control arm drop brackets

short arm. im pretty sure they are rubicon express. I currently have just the stock steering. Im planning on going with the Inverted T/Chevy 1 ton TRE set up. I dont think I need a drop pitman arm. I have a rubicon express track bar and mount that it came with not sure if it drops it down or...

just finnished installing my lift how do i figure out how long my upper and lower adjustable control arms need to be? its a 95 XJ

so i have lifted my 95 XJ 4in in the back and 3in the front so far. I still have stock control arms and installed an adjustable track bar. now my steering is all messed up. besides feeling alot looser then it did before the jeep now veirs to the right. I know my tie-rod ends are not in the...

I have a 1995 XJ I just finished installing a basic lift in. I have leafs spring with add-a-leaf and shackles. Im guessing its about 4in and in the front I have 3 in coils. I also have an adjustable track bar installed. Im will be adding a coil spacer to even it out. Since lifting the jeep I...