Recent content by BisonTechie

Just in case anyone is looking, I ended up replacing the right front bearing assembly which fixed the problem.

I just got done replacing the leafs on my '88 Cherokee. I bought the springs and bushings from Quadratec. The ride is a little stiff but should keep the height when towing a trailer. The original leafs were worse than your photo. They were inverted with no load.

I don't know if you have had any luck yet but I just went through this with my 88 Cherokee. The captive nut in the unibody will push the bolt out of a rusted sleeve until it runs out of threads. In my case I ended up torching off the bolt and part of the sleeve to get the spring off. The...

I have found no evidence of an accident or the vehicle being hit. I'm planning on checking the wheel bearings and rotors this weekend. Don't know much about checking the rest of the front 4WD axle. The shop only did a 2 wheel alignment. I'll enter the info I got when I'm back from my trip.

I just bought an '88 two weeks ago also. Had the same problem. There is a port on the fuel rail that should hold pressure when shut off. I found that there was no pressure when the engine was shut off. After pulling the fuel pump from the tank to replace it I found the hose from the pump to...

I have looked in the forums and have not found the same issue. I just got the Cherokee, replaced the tires and got the front end aligned. The shop said the alignment was within spec but that they could not make any further adjustments as they could not install any more shims. It drifts slowly...