Recent content by BayStYat

Tim, thanks. I will do this test and see. I considered tires but the vibration is only while on the gas on concrete. Once i let off the noise stops that i can tell.

i do not. but the transfer case is dropped

2001 XJ 3" RC lift 231 crank case stock front rear axles. at 30+ mph i get a vibration that starts then stops over and over and over. its methodical, not random. it last for 2 seconds then stops for 2 seconds then again and again and again etc. Only under acceleration, when i let off the...

i also have no front end noise or clunks

i did. i cant create any movement with a huge pipe for leverage.

if there is a camber issue, wouldn't be all the time? I dont have an issue on flat ground but any angle of the road its out of wack when parked.

ok the wheel bearing?

man, never jumped it ahahahah. ball joints tight, axle tube and inner C look fine. i am at a loss. just the driver side.

weld in?

ok. I am gonna check my ball joints now to see if they are worn out. Then i will get the alignment thanks Funny though depending on the angle of the road when the parked, sometimes the negative camber is noticeable and some times its normal.

Ole Santa done good! Merry Christmas my friend.

i havent got my alignment yet which it needs but i dont see and adjustment for camber.

I have an issue on my drivers side. I’m not sure what would cause a negative camber problem? Thanks for any help. I have a 3.5 lift on 31s I looked for anything bent and from my eyes things look normal.

i thought about it but did not have a way to put a curve in the metal to mount the base to.

thanks, gonna add one on each side in the center.