Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I wish I could remember better, but it has been almost 3 years since I did mine. I do remember taking the front seats, center console, and dash completely out. I was then able to open things up just enough to get the heater core out. It was a lot more work, but it was worth it to me to keep...
Here is an update, and boy do I feel stupid. After many attempts to figure out exactly what the noise was, my uncle and I were able to pinpoint the noise. About a year ago I replaced my exhaust manifold with an APN header. While in there I noticed that my motor mounts were shot. So, I made...
Update:
I got under the Jeep today to scope things out. There was nothing obviously wrong except one of the exhaust hangers wasn't hooked up correctly. So I thought that maybe the noise I was hearing was the exhaust rattling against the cross member that supports the transmission. I wired it...
I don't get to drive my XJ as often as I would like any more. But every chance I get I take it. Yesterday I needed to move some stuff around between my house and my parents house. I used my trailer which is a 2 place ATV trailer. I didn't have to move anything heavy, just a little bit of...
I have been getting pretty poor gas mileage lately. And I think that I might have found the problem. My fuel pressure seems to be too high. At idle with the vacuum line connected I get 39 psi. With the vacuum line disconnected I am up near 45 to 47 psi. The haynes book says to check for a...
Sorry that it has been so long since I have replied. And thanks to all of you for replying. The more I think about it the more I think I will keep it. I would just miss it too much when it was gone. I really love the XJ's. I just wish that mine didn't have so many problems. I sure have...
I have a 93 XJ that I have owned for about 3 years now and I am debating on weather or not I should sell it. My boss just recently purchased a 2008 Toyota Tundra and I inherited his old 2001 Tundra. A nice perk to go along with my job. It isn't mine, it is still owned by the company. But it...
Well, here is an update. I took my Jeep into a local muffler shop. I had them check out the CAT. They said it was great. Plenty of flow and good pressure. So, I think that has been ruled out. I also changed my spark plugs. I am not sure if I gapped them wrong the last time that I put them...
Well, I have spent most of the day trying to hunt down my problems. I checked the cat this morning before I started the Jeep. I couldn't hear anything rattling around inside. I checked the CTS, cold it was 11,000 ohms, operating temperature 800 ohms. TPS closed .738v TPS wide open 3.6v. I...
I really am ready to sell my XJ and get something that will run right with out emptying my pockets. Today was just about all I can take. Most of the problems that I have had with my Jeep have been things like rust and worn out steering parts, bad springs, shocks and brakes. I can handle all...
I have a 93 that did the same thing to me. It was after I went to the local landfill. It was really muddy and nasty and I had a hard time backing in with my trailer. I had "Mud." If you could call it mud, from the landfill all over everything. On the way home I noticed your exact problems...
I love my new bushings. I really should have done it sooner. I didn't tap for grease fittings, but I did put an ample amount on during instalation. They haven't squeeked yet. They did make a huge improvement in the way that it rides and drives. The only downside that I can see so far is...
I just got done putting these in my XJ last weekend.
1=Upper Front
2=Lower Front
3=Upper Rear
4=Lower Rear
1=M02410
2=M02409
3=M02411
4=M02415
For command track front axle, right side upper at axle, use M02412
It wasn't too hard to figure out where the Thrust Washers went. It is pretty much...