• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Some Details About a PSC SP1205C Power Steering Pump

Mine did not come with a pulley.

A special power steering pulley puller/remover is required. You can probably "rent" one for free from your local auto parts store.
 
Mine did not come with a pulley, but I highly recommend their 4.5" pulley for better idle/low end performance.
 
My pump is less than 3 months old and is already leaking. I tried a 13.8 x 2.4 mm one and it still leaked and tried leaving the factory one and a 13.8 x 2.4 mm one and it still leaked. Was wondering if anyone else had this problem and if anyone had an idea of a way to keep it from leaking?
 
Jdub7430 said:
My pump is less than 3 months old and is already leaking. I tried a 13.8 x 2.4 mm one and it still leaked and tried leaving the factory one and a 13.8 x 2.4 mm one and it still leaked. Was wondering if anyone else had this problem and if anyone had an idea of a way to keep it from leaking?
Click to expand...

Maybe a new reservoir but the proper installation is critical with special attention paid to the retaining clips.
 
Anak said:
I replaced the O-ring from PSC with a 14mm x 3mm Metric O-ring:

JeepPWRStringTankSealOPT.jpg
Click to expand...

That was November, 2018. No issues since then.
 
You must log in or register to reply here.

Similar threads

H
Can a bad power steering pump make a belt hop??
Replies
8
Views
220
RCP Phx
R
S
to drill or not to drill
Replies
4
Views
2K
srb531
S
S
WJ Power steering pump upgrade
Replies
5
Views
4K
srb531
S
D
XJ Rear Hatch Lift Or Power Glass?
Replies
11
Views
146
Veeb0rg
Veeb0rg
ehall
steering overhaul
Replies
6
Views
119
XJEEPER
XJEEPER
Back
Top