jk_surgeonfish
NAXJA Forum User
- Location
- AZ
Again...why does it seem like a simple thing just does not end up that way.
The original SYE is from ProComp from around 2008. I called and got the part number for the rear output shaft seal that goes around the yoke. It is my understanding that the Procomps were make by Teraflex. The invoice from the shop that installed showed a part number of 4006. I only show 4007 in my research. Anyways I put in the following based on ProComps recommendation: Napa 18658 SKF.
Leaked like the titanic around the rubber seal that makes contact with the yoke. :smsoap:
So I called around and it was suggested I put in a National 473179. Put that in and it was better but still leaks around the rubber seal.
The National 473179 when you measure it against the original seal is the best fit.:smsoap:
Any recommendations on what seal I need to be using?
Thanks!
The original SYE is from ProComp from around 2008. I called and got the part number for the rear output shaft seal that goes around the yoke. It is my understanding that the Procomps were make by Teraflex. The invoice from the shop that installed showed a part number of 4006. I only show 4007 in my research. Anyways I put in the following based on ProComps recommendation: Napa 18658 SKF.
Leaked like the titanic around the rubber seal that makes contact with the yoke. :smsoap:
So I called around and it was suggested I put in a National 473179. Put that in and it was better but still leaks around the rubber seal.
The National 473179 when you measure it against the original seal is the best fit.:smsoap:
Any recommendations on what seal I need to be using?
Thanks!