1993 xj wiring help needed please

Hello everyone, I was hoping someone could help me out.

Vehicle details
1993 jeep Cherokee XJ, (was) a 4.0 with an automatic transmission.
(Currently) LS 6.0/NV4500/ GM Transfer case. The harness for the ls is stand alone so that is taken care of.

Issue
When I got the jeep it was a roller and all the wiring was cut out of the engine bay. The only connector that was still intact was the plug for the headlights. I am wanting/ needing to wire up / confirm what I need to wire up lights,windshield wipers, heater, grounds harness power wires stuff like that. I assume all I need is wire coming out of the bulkhead connector but I can not find a pinout that matches what I have, the pinouts I find dont match the locations that the headlight plug is wired into unless there is more tied into that plug than lights. Also the wiring colors definitely dont match. Any help would be greatly appreciated.

http://cruiser54.com/?page_id=365

You'll find the 93 factory TSM there.

thanks for that do you happen to have the correct bulkhead pinout??

Do some searching, try ebay, for a true factory troubleshooting electrical manual. I have it for the Renix and it shows absolutely everything down to the routing, connectors with pinouts and drawings. It also has full diagnostic/troubleshooting info.

https://www.ebay.com/itm/362344312870?hash=item545d677026:g:hU8AAOSwnvVbGCAV

Jesseparker56 said:

thanks for that do you happen to have the correct bulkhead pinout??

Click to expand...

Download the 94 TSM from Cruisers site. The 94 is the same as 93.

thank you all for your help