Hey all-
I installed an Advanced Adapters SYE and a new Tom Woods rear drive shaft on my NP231 about 6 months ago and all seemed ok. I then re-geared and had my D44 put in the rear and started to get some knocking noise. Ran through the gears with the t case in neutral and no noise. Pulled the rear shaft and ran in it in 4hi and 4lo with no noise. As described it is a knocking noise that is very light under acceleration, almost non-existent, but is much more pronounced under deceleration, especially in 3rd gear. Before I tear it apart/rebuild, anyone have any ideas? Any help is greatly appreciated.
Thanks!
I installed an Advanced Adapters SYE and a new Tom Woods rear drive shaft on my NP231 about 6 months ago and all seemed ok. I then re-geared and had my D44 put in the rear and started to get some knocking noise. Ran through the gears with the t case in neutral and no noise. Pulled the rear shaft and ran in it in 4hi and 4lo with no noise. As described it is a knocking noise that is very light under acceleration, almost non-existent, but is much more pronounced under deceleration, especially in 3rd gear. Before I tear it apart/rebuild, anyone have any ideas? Any help is greatly appreciated.
Thanks!