• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

JET PCM for Dodge RAM/Durango w/ 5.7 $200

rparker762

NAXJA Forum User
Location
Glendale, AZ
I bought this Jet module for my 03 Ram from my buddy who was selling his 04. We thought it would work but the harness is wrong. The chip was installed for just about 1000 miles. The PN is 90406.

IMG-20110809-00255.jpg

IMG-20110809-00256.jpg


Description from Jets website here: http://www.jetchip.com/JET_Chips_Modules.asp



Performance Modules:

JET offers a wide range of Performance Modules for your Ford, GM or Dodge vehicle.

For more information about our Dodge Performance Modules click here.

For more information about our GM Performance Modules click here.

For more information about our Ford Performance Modules click here.

DODGE MODULE - The JET Performance Module for Dodge, Chrysler and Jeep vehicles is a JET exclusive. Dynamic Spectrum Tuning provides power gains across the entire power band-not just at full throttle. Point by point air/fuel ratio, ignition advance and various other tuning points provide performance gains of up to 25 horsepower. Improves throttle response, acceleration and low end torque. Simple, plug-in installation in less than 30 minutes. Available in Stage 1 and Stage 2.

*For 1989-Current Dodge cars, trucks and SUV's.

STAGE 1 - For stock or mildly modified vehicles. Fuel and timing curves are modified for optimal performance and mileage using less expensive, lower octane fuels. Programming is designed to burn fuel at peak efficiency, which results in improved performance and mileage. Daily drivers can use lower cost regular fuel for potential mileage gains, but for optimal performance gains use of mid-grade or better is recommended.

STAGE 2 - Designed for the performance enthusiast, the Stage 2 features more aggressive programming to make the most horsepower and torque available. Fuel and timing curves are extensively modified for peak performance and drivability. Requires use of 91 octane fuel, 180 degree thermostat and free flow exhaust. Also works well with aftermarket intake systems, mass air sensors, TBI spacers, etc.

*See Domestic Information section for horsepower gains and dyno charts.

*Stage 2 part numbers end with "S".


$200.00 obo or $210 shipped
 
Back
Top