I am swapping and building a lot of stuff on my xj and first on the list is building and 8.8 with gears to match my 33s. Next up is swapping the ax15 to get my Puegot out. while I have the transfer case out I was thinking of installing a sye. I was wondering if a front driveshaft can be used with no lift? I am installing a lift later when I finish collecting the parts so for a while it will have no lift to speak of. I can throw the transfer case back in without the sye and use the stock driveshaft but I thought if the front driveshaft would work I can avoid dropping the transfer case again.
I searched and I found people using the front driveshaft for lifts and custom shafts for no lift but I couldn't find much info for fully compressed length if I went over a speed bump or whatever with no lift would it be too small?
Thanks
I searched and I found people using the front driveshaft for lifts and custom shafts for no lift but I couldn't find much info for fully compressed length if I went over a speed bump or whatever with no lift would it be too small?
Thanks