IntrepidXJ
NAXJA Member #647
- Location
- Grand Junction, CO
Can anyone verify the thread pitch on the WJ TREs for me?
In this post (the only info I have been able to find on it):
http://www.naxja.org/forum/showthread.php?t=2444
it says M24 x 1.5? However, 1.5 is an SAE measurement.....correct? Or are these TRE threads different than standard taps/nuts?
I am finding M24 x (1mm, 2mm & 3mm).
Thanks.
In this post (the only info I have been able to find on it):
http://www.naxja.org/forum/showthread.php?t=2444
it says M24 x 1.5? However, 1.5 is an SAE measurement.....correct? Or are these TRE threads different than standard taps/nuts?
I am finding M24 x (1mm, 2mm & 3mm).
Thanks.