• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Mod

So I ended up using a nut and a bolt to get it slightly out on the upper section but the scrap plates I had weren’t long enough so I used a piece of a longer steel I had but it wasn’t strong enough and bent so I’m going to try and get a piece of 1/4 inch angle iron and attempt it again! Hopefully it gets me close enough. I made a template today for tie in brackets and used the passenger side because it was straight but when I moved it over to the DRS side I was off half a hole on each one because of the smash. Good thing I didn’t order already made brackets haha


Sent from my iPhone using Tapatalk
 
Washington’s been very rainy so today was the only day I could make a little bit of progress haha hopefully I get another nice day soon!


Sent from my iPhone using Tapatalk
 
Back
Top