• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Front fenders

ATTACH]
 
Thanks I thought about that for 30 seconds then welded them on
https://photos.app.goo.gl/Piy2JEFuG1NxaZkH6

It wont be just flat fenders when I'm done.
https://photos.app.goo.gl/PQJWiQ1EhxES2Fsu6
I haven't done any bending in awhile. This is just a bend I had left over from a project.
https://photos.app.goo.gl/xn5rW9iqTaVJfM9u7

Will start on the rear at some point. Itl be cut out to the door line.

https://photos.app.goo.gl/xn5rW9iqTaVJfM9u7

https://photos.app.goo.gl/US8RuReir4qmuUre7

Might tie a roof rack to carry a spare when it said and done
 
Thanks. My metal supplier didnt have 1 3/4 tube in stock. They had to order out of salt lake so I told them to hold of. I did get 500 in 2" .25 square tube and 1/4" x5 and 4" plate
 
Cool.....
 
Last edited:
I think I'm going to cut fender hack 1 3/4" and weld tubes in. To strength and give a better sliding surface.
 
a little boxy for me, but they look solid. nice work
 
Yeah me to wish I found some bigger tube to make my bending jig.

My die is 5.5 clr so itl hide the body fender
 
You must log in or register to reply here.

Similar threads

E
My xj vids thread
Replies
0
Views
2K
Evan03
E
O
Where is the VIN stamped?
Replies
7
Views
1K
Unclewolverine
U
J
Revamping My 447K Mile Daily Driver XJ
Replies
3
Views
65
Numbers
Numbers
macgyvr
Metal Cloak I resolve to Offroad with Metal Cloak
Replies
0
Views
1K
macgyvr
macgyvr
B
Blow torch to re-activate clear coat?
2
Replies
26
Views
4K
bradleyheathhays
B
Back
Top