Destroyer
NAXJA Forum User
- Location
- Milton, GA
Hey ya'll, been a while since I was on the forum. Long story short an illegal totalled my 99 that I'd had for 16 years. Picked up a clean 2001 4.0 AW4 2wd with no motor to swap my drivetrain into. Donor carcass is a 99 4.0 AW4 231 w/ 120k. I have the 99 drivetrain pulled and cleaned up, ready to go in this weekend.
Been searching for the last few days but wanted to touch on the main points and make sure I'm not missing anything before I get started.
I'm in an emissions county so obviously running the 2001 PCM/harness/Cali exhaust.
Harness wise: Have complete 2001 engine harness, coil rail, cam sensor to swap onto my motor. 2wd harness though so lacking tcase sensor for now. Anything else missing there? Any TCU issues to be aware of between the 01 harness and 99 trans? Will my 1-2 manual override switch still be possible?
Exhaust: Have a banks header for the 2001 Cali setup so should have exhaust port mismatch covered.
4WD conversion: Already swapped tcase shifter and light harness into the 01. Front axle from the 99 is trashed so staying with the beam axle for a while. Have correct driveshafts from the 99 still so I'm good there.
Anything else I'm missing please let me know. Been trying to get everything ready and get parts ordered so I can get back on the road so may have forgot/overlooked something.
Thanks!
Been searching for the last few days but wanted to touch on the main points and make sure I'm not missing anything before I get started.
I'm in an emissions county so obviously running the 2001 PCM/harness/Cali exhaust.
Harness wise: Have complete 2001 engine harness, coil rail, cam sensor to swap onto my motor. 2wd harness though so lacking tcase sensor for now. Anything else missing there? Any TCU issues to be aware of between the 01 harness and 99 trans? Will my 1-2 manual override switch still be possible?
Exhaust: Have a banks header for the 2001 Cali setup so should have exhaust port mismatch covered.
4WD conversion: Already swapped tcase shifter and light harness into the 01. Front axle from the 99 is trashed so staying with the beam axle for a while. Have correct driveshafts from the 99 still so I'm good there.
Anything else I'm missing please let me know. Been trying to get everything ready and get parts ordered so I can get back on the road so may have forgot/overlooked something.
Thanks!