|
|
|
|||||||
| OEM Tech Discussion Forum for OEM (Original Equipment) or stock XJs and MJs. |
 |
|
|
Thread Tools | Display Modes |
|
#1
February 18th, 2005, 07:32
|
|||
|
|||
|
Transfer case mount/bushing/cushion
I get a thump under my drivers side seat when going over bumps. I checked everything for play/slop: sway bar, transmission mount, exhaust, ect, everything was O.K there. I noticed the transfer case has about 1/2" of vertical movement and there's about the same amount of space between the skid plate/crossmember. Should the bushing under the transfer case fill the whole space between the case and the crossmember? Or should I look somewhere else?
|
|
#2
February 18th, 2005, 07:57
|
||||
|
||||
|
Re: Transfer case mount/bushing/cushion
Sounds like your trans support is toast. There shouldn't be any t-case movement as you described. Check your motor mounts while your at it. If the drivers side is toast the t-case might whack the cross member as the engine trans and t-case wobble around under your hood.
Brad
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| transfer case woes,.. | BILLXJ | Modified Tech Discussion | 15 | May 24th, 2005 14:25 |
| Transfer case spline count info wanted. | lunghd | OEM Tech Discussion | 4 | May 2nd, 2005 18:54 |
| transfer case linkage fabrication ideas,.. | bxj | Modified Tech Discussion | 7 | June 22nd, 2004 08:14 |
| Repairing Cast Aluminum Transfer Case | BrianJr | OEM Tech Discussion | 5 | January 12th, 2004 10:41 |
| ..NP 231 transfer case studs,.. | BILLXJ | Modified Tech Discussion | 4 | May 8th, 2003 12:06 |
Linear Mode
