Hi everyone, to start I have searched hi and low and found many different ways of doing this but of course not the way I want to.:helpme:
I have a 1998 jeep cherokee sport with NO power features - (cruise control/windows/ambient temp ect.)
I am installing an electric fan setup and I need to have an ignition on source to switch the relay on. I would like to use an empty fuse so I don't have to cut into any factory wiring. I know I must have some since I don't have any power features on the jeep. I bought a cool fuse with a wire that comes out to connect to the relay, now I just need to know where to plug it in at. I am trying to do this at the PDC as it is close to where my relays are at. I have open slots there I just don't know what is what. My haynes manual is confusing as hell. If you have a picture of your PDC with an arrow pointing to the slot or something that would be awesome as I am not great with electrical stuff. Thanks in advance!
I have a 1998 jeep cherokee sport with NO power features - (cruise control/windows/ambient temp ect.)
I am installing an electric fan setup and I need to have an ignition on source to switch the relay on. I would like to use an empty fuse so I don't have to cut into any factory wiring. I know I must have some since I don't have any power features on the jeep. I bought a cool fuse with a wire that comes out to connect to the relay, now I just need to know where to plug it in at. I am trying to do this at the PDC as it is close to where my relays are at. I have open slots there I just don't know what is what. My haynes manual is confusing as hell. If you have a picture of your PDC with an arrow pointing to the slot or something that would be awesome as I am not great with electrical stuff. Thanks in advance!