mknack
NAXJA Forum User
- Location
- california
I'm trying to figure out which universal joints that I should use to replace the old ones on my Cherokee. I have a 2000 Cherokee classic 4wd. I have a bunch of mods on it form the ground up. The ones that would make a difference in my u-joint choices are as follows:
6.5 inch Rustys long arm kit
running 33/12.5's
air lockers
regeared to 4.10/4.11's
have slip yoke eliminator
tom woods drive shaft
I have a dana 30 front axle and a 8.25 in the rear.
Im planning on replacing all of the u-joints in the driveshaft from the front to the rear. Not the axle ones.
I just want to make sure the fit and the strength are right for my application. any help would be great. I have checked and searched the forums, but I cant find anything that is specific to my type of question.
Thanks
6.5 inch Rustys long arm kit
running 33/12.5's
air lockers
regeared to 4.10/4.11's
have slip yoke eliminator
tom woods drive shaft
I have a dana 30 front axle and a 8.25 in the rear.
Im planning on replacing all of the u-joints in the driveshaft from the front to the rear. Not the axle ones.
I just want to make sure the fit and the strength are right for my application. any help would be great. I have checked and searched the forums, but I cant find anything that is specific to my type of question.
Thanks