4x4JeePmaNthINg
NAXJA Forum User
- Location
- Colorado
Im planning buying some cheapo bearings for set up /regearing again, staying with 456.
Can i use the current races for setup?
Can i use the current races for setup?
Probably a little oiling problem combined with a lot of wheel spinning!
I thought it was auto lockers drove sketchy in the front. limited slip shouldnt be too much different than stock other than diverting a little more torque to the slipping wheel instead of almost all.
I may just keep it open, Idk, never planned on this weirdness going on. I wish I knew why the diff did this.
To my knowledge xj only came with rear LSD option. The front was always open.
Also as a side note (I personally think a front LSD would be invisible in front for drivability) but the breakaway torque is normally 90 ftlbs or so on an LSD correct? That could cause more "feel" than a lunchbox as they require basically nothing to differentiate verses the 90ish ft lbs of an lsd...
Thoughts?
Sent from my SM-G950U using Tapatalk