NebraskaXJ
NAXJA Forum User
- Location
- Nebraska, USA
Planning on doing the homemade rock sliders to replace my rusted away rocker panels. I've got a got a few questions.
1) What size steel tubing should I use?
2) What length? I've found 60.5" for the pre 97 but I'm not sure if post 97 is the same.
3) Where did you weld it in? Directly to the unibody seems like the best bet but I'm not sure if there's anywhere else.
Sent from my SM-G950U using Tapatalk
1) What size steel tubing should I use?
2) What length? I've found 60.5" for the pre 97 but I'm not sure if post 97 is the same.
3) Where did you weld it in? Directly to the unibody seems like the best bet but I'm not sure if there's anywhere else.
Sent from my SM-G950U using Tapatalk