tumble
NAXJA Forum User
- Location
- Tacoma, WA
I need to relocate one of my transmission lines to make some room, and I'm considering my options. I could use a conversion fitting for the factory hard line to -6 AN and cut my hard lines and splice in a section of flexible tubing and leave the factory ends intact. I could probably even just cut and flare the factory tubing and just clamp in some rubber hose.
But I'm considering converting everything from the transmission forward to two new flexible lines from the transmission outlet all the way to the factory cooler. It looks like the transmission side requires 14mm-1.5 to -6 AN adapters and o-rings. I haven't found any part numbers or sizes to convert back from 3/8-inch hose to the factory transmission cooler ports.
Does anybody have a write-up or recommendation?
But I'm considering converting everything from the transmission forward to two new flexible lines from the transmission outlet all the way to the factory cooler. It looks like the transmission side requires 14mm-1.5 to -6 AN adapters and o-rings. I haven't found any part numbers or sizes to convert back from 3/8-inch hose to the factory transmission cooler ports.
Does anybody have a write-up or recommendation?