Hi everyone, so after searching around on here I haven't quite been able to find somebody who posted a similar issue. I just purchased a 1998 Jeep Cherokee Limited. The weird issue that I am having is; the check engine light is not on, but when I took it down for inspection to get the new license plate, they told me that it was throwing two codes, P0700 & P0705. Also, the shift lever is off almost one entire selection. In order to shift into drive, I need to drop down into 3rd. The little window is not the problem, I actually have to step on the brake to go past the "D" stop and about halfway to the "3" it will shift into drive. Everything I can read about these codes says that it is the Neutral Saftey Switch, I am just skeptical because the shift lever is kinda messed up. Is there a way to adjust the lever so that it is correct on all the stops? Also, I know the Engine light works since it lights up briefly when I first start it, why isn't it on? I took it to autozone and they confirmed the codes. Any help would be amazing! Hopefully someone can post some photos also?