Lake919
NAXJA Forum User
- Location
- Mobile, AL
Hi guys so I’ve been tackling my ball joints today, and they were a pain in the ass to remove and so far have been a nightmare to reinstall. I was able to put the bottom in with no issues, I cannot figure out a way to get the angle correct to reinstall the top one. My problem is arising at the bottom of the top ear. The bottom isn’t flat so when I start tightening the press that one kicks out at a stupid angle and the joint starts going in at a dumb angle. Can anyone tell me what I have to do to stop this? 1995 XJ Dana 30