Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Search did not give me much. I'm ready to cut my rear quarter panels and wrap the bumper around. I've read fold and reweld the panel after cutting. Is there more? Any advice, tips, or smart ars comments are welcome. Thanks
I did not cut mine up so high, was a little easier to leave the lower bend there. I also "skinned" the outer fender from the rest of the metal and used it to fold up underneath to plug the hole without any extra metal needed. Left some of the inner fender to for the same purpose.
Do the passenger side first, you can see much better and makes it easier to figure out.
If I had to do it again, I would have cut lower too. This also gives you a better place to make the fold since it is in the same direction. If you notice, add some angle or at least gusset the rear crossmember, especially if you plan to use the rear bumber mounts.