sprngfldxj
NAXJA Forum User
- Location
- Springfield, Colorado
Have the XJ almost ready to weld in replacement floor sections and patches, and I am looking to use one of the products above.
Which is the best to go with and is there a specific proceedure to be aware of other than the directions on the can?
I have cut away all the bad stuff, ground most of the other stuff and will sand the rest of the surface, is that enough or is there more?
Which is the best to go with and is there a specific proceedure to be aware of other than the directions on the can?
I have cut away all the bad stuff, ground most of the other stuff and will sand the rest of the surface, is that enough or is there more?
