Wiring diagram for ignition switch

Anybody have one?

My lock cylinder froze up and I just got a universal replacement to mount in the dash. This is my offroader only so I am not to worried about theft. I was just gonna get some togles and a momentary, but this switch was cheaper than buying that stuff.

TIA

Andy

It would be a lot easier to just replace the frozen lock tumbler in the steering column. You can get 'em at Pep Boys for about $10, and "rent" the tool you need to replace it.

I just figured it out with a test light and had it going in about 10 minutes. Easy job. Got an ignition switch for a CJ and put that in there, made pigtail adaptor harness to go from the factory spade terminals to ring terminals on new switch.

Would be easy to rent a tool if the nearest place with tools to rent wasn't 100 miles away, autozone.