Valve cover bolt and driveshaft strap bolt size...

W

wy_jeep

NAXJA Forum User

Location

South WY

• Apr 7, 2010

• #1

Can anybody tell me what size these are? I need two valve cover bolts (fastens valve cover to the head) and two drive shaft strap bolts (fastens straps to hold driveshaft to the rear axle). I took one of each to compare to hardware stores and ended up losing them.

Thanks!

 

joe_peters

NAXJA Forum User

Location

Grants Pass, OryGun

• Apr 7, 2010

• #2

Year/engine/trans/transfer case/axles?

Partial listing on 5-90's website: http://www.geocities.com/JeepI6Power/screws.html

 

W

wy_jeep

NAXJA Forum User

Location

South WY

• Apr 7, 2010

• #3

95, 4.0L, AX15, 231, D30 and 8.25. I checked link and didn't find anything older than 90.

 

C

cruiser54

NAXJA Forum User

Location

Prescott, Az

• Apr 7, 2010

• #4

Might be time to grab a coupla more samples off your rig to take to the store............

 

kastein

NAXJA Member

NAXJA Member

Location

Rainy side of Washington

• Apr 7, 2010

• #5

I'd hit the junkyard and swipe a couple.

Driveshaft bolts are 3/8-24 UNF iirc, I'm not sure on the valve cover bolts. They should be the same on any 4.0 though.

 

MoparManiac

NAXJA Forum User

Location

Amherst, NH

• Apr 7, 2010

• #6

kastein said:

I'd hit the junkyard and swipe a couple.

Driveshaft bolts are 3/8-24 UNF iirc, I'm not sure on the valve cover bolts. They should be the same on any 4.0 though.

Click to expand...

5/16-24 I thought...?

 

kastein

NAXJA Member

NAXJA Member

Location

Rainy side of Washington

• Apr 7, 2010

• #7

MoparManiac said:

5/16-24 I thought...?

Click to expand...

yeah... you're correct. My mistake.

I think 5-90's page has the valve cover bolt size but I am not sure, it's already been posted.

 

D

doktor_x

NAXJA Forum User

Location

Colorado

• Apr 7, 2010

• #8

The valve cover bolts are 1/4-20 on my 2000. I'd imagine they're the same for any 4.0.