cgmrdc
NAXJA Forum User
- Location
- Lee's Summit, Rolla MO
Long story but can be foundhere: http://www.kcjeepclub.org/forum/viewtopic.php?t=12960
short story... knock returned after rebuild... check flex plate tight and not cracked.
here is the #5 lower rod bearing where the knock is coming from...
i also plasti gauged at BDC and at 9 o clock and both were between .0015 and .002. desired clearance is .001 but allowable is .003
thanks for the help... im totally lost what could cause this and its my DD.. and ony vehicle... and there are only about 500 miles on this bearing
short story... knock returned after rebuild... check flex plate tight and not cracked.
here is the #5 lower rod bearing where the knock is coming from...
i also plasti gauged at BDC and at 9 o clock and both were between .0015 and .002. desired clearance is .001 but allowable is .003
thanks for the help... im totally lost what could cause this and its my DD.. and ony vehicle... and there are only about 500 miles on this bearing