- Location
- San Diego
Do the WJ knuckle swap they said, you'll love it! :looney:
So I did, and I do love it, but it was a little bit of work
Anyway, I'm running offset tie rod ends and my questions are as follows:
1. Looks like I'll be running 17" rims with around 4" of backspacing. I could maybe go with 16", but it looks really close with the offset TRE's. Not sure if I'll run aluminum or steel wheels. For those with similar set ups, what size rim and what material are you running? Backspacing? I will NOT be running spacers.
2. I'm going to run 33x12.50 MT's. What width rim do you all run with this size? I can do 8" or 9" in most of the rims I'm looking at. Any input? Or am I splitting hairs over 8" vs. 9"?
Thanks.
So I did, and I do love it, but it was a little bit of work
Anyway, I'm running offset tie rod ends and my questions are as follows:
1. Looks like I'll be running 17" rims with around 4" of backspacing. I could maybe go with 16", but it looks really close with the offset TRE's. Not sure if I'll run aluminum or steel wheels. For those with similar set ups, what size rim and what material are you running? Backspacing? I will NOT be running spacers.
2. I'm going to run 33x12.50 MT's. What width rim do you all run with this size? I can do 8" or 9" in most of the rims I'm looking at. Any input? Or am I splitting hairs over 8" vs. 9"?
Thanks.