This is a used Tom Wood's Custom Drive Shaft CV style drive shaft with a slip yoke that goes into the transfer case. I ran this on my 'small' lifted 88 XJ 242 for about a 3000+ miles. I had vibes and didn't want to do a full SYE. I've since found out my vibes were not from the drive shaft and have since gone back to the stock style shaft.
Tom Woods Custom Drive Shafts is in Ogden, UT. and they are basically my neighbor. I just had this "triple checked" (their terminology) by Tom and it's all balanced, lubed, and ready to install.
Measurements; from the axle end u-joint to the first CV u-joint is 27", to the second CV u-joint is 29 1/2", and overall length is 35 3/4"
Sells new for $389.00. Looking to get $200.00/shipped. Located in Ogden, UT.
PayPal is dfrazier at pacifier dot com
Best way to get a hold of me is at dfrazr at g mail dot com (goes to my phone)
Thanks,
Dan.
Tom Woods Custom Drive Shafts is in Ogden, UT. and they are basically my neighbor. I just had this "triple checked" (their terminology) by Tom and it's all balanced, lubed, and ready to install.
Measurements; from the axle end u-joint to the first CV u-joint is 27", to the second CV u-joint is 29 1/2", and overall length is 35 3/4"
Sells new for $389.00. Looking to get $200.00/shipped. Located in Ogden, UT.
PayPal is dfrazier at pacifier dot com
Best way to get a hold of me is at dfrazr at g mail dot com (goes to my phone)
Thanks,
Dan.
