Down under
NAXJA Forum User
- Location
- Australia
Hi! I need help with some facts on the Chrysler* rear 8.25- 3.55 diff set up, (also reffered to as the coperate diff) running 29 spline with the trac lok 7062 LSD. And some info on the pinion gear...
Getting the correct info in Australia is very hard!*
Firstly*
1/ outer wheel bearings for this, ( flat roller type) these are near impossible to be found with major bearing companies here! Unless you want to hand over*$400*for a pair!*
Dose anyone know the exact specs to help try and a match a set + the seals?*
Are they the same size as any other diff for compatabiltt
2/ the carrier is the LSD version. Was this carrier fitted in any off the dana units?*
If so, are the clutch kits, carrier bearings* etc the same?*
3/ the pinion, basically* same questions,* are any of the bearings* the same as other model dana's.
The yoke has a Spicer stamp on it.*
3/ did Dana have anything to do with this set up?*
Thanx in advance guys!*
Getting the correct info in Australia is very hard!*
Firstly*
1/ outer wheel bearings for this, ( flat roller type) these are near impossible to be found with major bearing companies here! Unless you want to hand over*$400*for a pair!*
Dose anyone know the exact specs to help try and a match a set + the seals?*
Are they the same size as any other diff for compatabiltt
2/ the carrier is the LSD version. Was this carrier fitted in any off the dana units?*
If so, are the clutch kits, carrier bearings* etc the same?*
3/ the pinion, basically* same questions,* are any of the bearings* the same as other model dana's.
The yoke has a Spicer stamp on it.*
3/ did Dana have anything to do with this set up?*
Thanx in advance guys!*