• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Wire identification

Figured it out, brake light wire. Clip that held the wire to the body near the brake light wore through and grounded it out. Burnt the wiring all the way to the switch at least. Rhd and lhd body wiring similar?
 
Wiring is similar, the wht/tan is the load side of the brake switch. The wire should only be melted from the ground point and switch, and the B+ side of the brake switch that goes directly back to the PDC.
 
You must log in or register to reply here.

Similar threads

B
Cable upgrade. A little confusion on a '91
Replies
0
Views
1K
BALTANAKT
B
O
2000 XJ Failed Colorado Emissions high CO
2
Replies
27
Views
2K
Ken M
K
M
92 XJ ECU connector
Replies
5
Views
138
Rob Mayercik
R
G
Red and Purple ignition wiring hot to touch with A/c and blower on high
Replies
0
Views
1K
gmcchamp99
G
egon
1000 and 1100 series steel
Replies
9
Views
3K
maxbraketorque
M
Back
Top