alsogotanxj
NAXJA Forum User
- Location
- north carolina
Well that was a mistake and now im stumped... I was trying to install a switch for my aux fan using the ground on the relay as some youtube video said. In doing so I fried the electronics in my jeep. I had assumed 85 would be the ground because thats what I saw in all the diagrams. But anyways I connected a wire to 85 and went to touch it to the ground and my fan didn't come on, but I heard clicking from the battery or somewhere near it.
Now my jeep will crank, but not start. Changing batteries hasn't fixed it. Fuses are all good.
My CEL will not turn on at all even on start up, I cant get codes to show on the odometer. It worked earlier today. I even tried to unplug the temp sensor to see if that would change anything, but it didn't. My battery and fuel gauges are also not working.
I tried unplugging the CPS, based on what I read in this thead, but that doesnt help either,
I'll be pulling codes tomorrow when my scanner arrives and Im assuming I fried the computer. What other diagnostic steps should I take?
Now my jeep will crank, but not start. Changing batteries hasn't fixed it. Fuses are all good.
My CEL will not turn on at all even on start up, I cant get codes to show on the odometer. It worked earlier today. I even tried to unplug the temp sensor to see if that would change anything, but it didn't. My battery and fuel gauges are also not working.
I tried unplugging the CPS, based on what I read in this thead, but that doesnt help either,
I'll be pulling codes tomorrow when my scanner arrives and Im assuming I fried the computer. What other diagnostic steps should I take?