• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

To do lists....

JohnX

Sarge
NAXJA Member
Location
Williams AZ
Just over a month away, what's on your list to get done between now and then?

Mine...

Finished mounting my beadlocks yesterday.
Need to put some wiring together for my CB.
Need to buy and install rear leaf springs.
Fix my door latch strike pin which fell into the pillar last time I was out.
 
Changed out my damaged steering box. Just ordered track bar and steering box braces to stiffen up the front. Might re-install the intake manifold if time permits.
 
Pick up rear tire carrier bumper from Julio
Install said bumper and gas tank skid
Change out damaged ECTS
Replace broken taillight from Moab
R&R diff fluids, maybe T-case.
RE-wire CB and radio
Clean out Jeep.
 
Patch holes in rear fenders from long ago removed Bushwhackers... probably not.

Get Sideways to build me a patch harness...cough, cough...so I can wire up my RAD shifter
 
I always seem to have a few projects on stand-by.

Weld and install DB DIY winch bumper
Install TNT Belly Skid plate
Re-install rocker gaurds, since I installed frame stiffeners
HD Offroad No-lift shackle relocation boxes
Set up rear bump stops
 
cut and rotate c's
weld on c-gussets
install new ball joints
Mount toys by troy high steer knuckles and vanco brakes on polished turdy
Purchase and install 30 spline inners with CTM joints and current chromo outers
Install axle into jeep
Swap out FT leafs with rear deavers
have crackers build new steering/trackbar and 3 link
Purchase install and plumb ARB compressor for front and rear lockers
Build bumpstops
Install camper shell on superduty and test flat towing jeep
pack cooler with ice and beer

Oh and build patch harness for Lurch.
 
Clean out Jeep (currently being used as a storage unit)
wash and vacuum Jeep
Install 37's and retorque my beadlocks
replace the bushings in my deavers and install them on the Jeep
cut and fold the passengerside lower quarter panel
weld shock mounts on the rear d44
Check fluids and service whats needed
fix the wiring to my lights
Install light bar if time permits
Wire up my reverse lights if time permits
 
Reinstall carpet and seats
replace fan
Change diff fluids
Grease up u joints, control arms, steering and whatever else
Change breaks
Smog the jeep

Clean up trailer from koh, pack it up with food and beer.
 
Possibly put in new compressor. May blow that off.
Fix rear end, hopefully just needs pinion bearings.



Or say screw it and go up in the little Jeep, it gets brand new Falken Wilepeaks tomorrow morning.
 
cut holes in my floor build bed cage
install shocks on said bed cage
finally weld on some rock sliders
install HD offroad stiffeners back and front. middles already done woo
 
Pick up rear tire carrier bumper from Julio
Install said bumper and gas tank skid
Change out damaged ECTS
Replace broken taillight from Moab
R&R diff fluids, maybe T-case.
RE-wire CB and radio
Clean out Jeep.

Tire carrier bumper installed.
Replaced Taillight.
Rear diff done, still need front diff
Partially cleaned Jeep.

Hopefully install AC delete bracket.
 
Just over a month away, what's on your list to get done between now and then?

Mine...

Finished mounting my beadlocks yesterday.
Need to put some wiring together for my CB.
Need to buy and install rear leaf springs.
Fix my door latch strike pin which fell into the pillar last time I was out.

Laziness prevails.

Fixed the door striker.
Bought a ham radio instead of wiring in the cb.
Haven't been able to get springs even ordered yet, about to give up and go to deaver instead.
 
weld in rear shock towers
weld in rear sheet metal
weld in rear quarterpanels
wire up new taillights
install/wire reverse lights
rebuild leaf springs
re-install leaf springs
weld lower shock tabs
re-install front ARB
replace driver front brake hose
fix steering leak
get jeep smogged.
 
make U/LCAs
install: drop brackets, coil springs, leaves, shackles, shocks, 33s
make rock rails.....might just bring a hammer
toss in lockrite
permanize vac disco or cable it
empty out 600lbs of trash from rig
toss in 600lbs of crap and roll out
 
Back
Top