Benthos
NAXJA Forum User
- Location
- Northern CA
I decided to replace my crank position sensor and everybody said get Mopar.
Right out of the box I noticed that the cable is over 2 inches shorter than the original. And I remember it being a pretty close fit and so I'm wondering if this is going to be a problem?
PN: 56027866AC
It's for a 99 Cherokee. The new one measures a total of 14.25 inches end to end and the old one is 16.5.
Are they all like this or do I have a defect?
I would like to figure out if it will reach before I reinstall it and put everything back in the engine bay only to find out that it won't connect to the harness.
Right out of the box I noticed that the cable is over 2 inches shorter than the original. And I remember it being a pretty close fit and so I'm wondering if this is going to be a problem?
PN: 56027866AC
It's for a 99 Cherokee. The new one measures a total of 14.25 inches end to end and the old one is 16.5.
Are they all like this or do I have a defect?
I would like to figure out if it will reach before I reinstall it and put everything back in the engine bay only to find out that it won't connect to the harness.