• NAXJA is having its 18th annual March Membership Drive!!!
    Everyone who joins or renews during March will be entered into a drawing!
    More Information - Join/Renew
  • Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Fog light switch removal

rain164845

NAXJA Forum User
Location
Usa
Does anyone know how to remove the panel down so that I can get to the dog light switch?
Thanks!
d6777478ed11cc92abb30494080142b3.jpg


Sent from my SM-G975U using Tapatalk
 
That front panel has to come off. IIRC ,there are 4 screws holding it in place. One just above the headlight switch. One just above the cigarette lighter and 2 on the underside area above the cluster. Next, pull that spacer off that sits below the steering wheel (it is only cosmetic and is held in place with friction). Last, grab the right side of the panel and pull it free. There should be 2-3 friction clips holding it in place so steady pressure should cause it to release. Once that panel is off it will become obvious how the switch areas are removed
 
That front panel has to come off. IIRC ,there are 4 screws holding it in place. One just above the headlight switch. One just above the cigarette lighter and 2 on the underside area above the cluster. Next, pull that spacer off that sits below the steering wheel (it is only cosmetic and is held in place with friction). Last, grab the right side of the panel and pull it free. There should be 2-3 friction clips holding it in place so steady pressure should cause it to release. Once that panel is off it will become obvious how the switch areas are removed

Yep, what he said!! Look under the upper surface of the bezel. You should see two in the instrument cluster section, and one each over the left side panel and over over the clock. The bezel is a tight fit pulling it out as it hits the steering column. You may want to loosen the column bolts to drop it a bit and give you more room.

Once the panel is off, there is a single screw on the left.
cgm9zBih.jpg

vc5ezB0h.jpg
 
Whatcha trying to do? The switch itself just snaps into the panel. You can remove the switch by unplugging the wiring to it, then squeezing the tabs on the top/bottom of the switch. Getting your finger or levering a screwdriver in the right spot to get the top side is the challenge though.

CBA74032_thumbnail.jpg
 
ack, forgot those last two (clock/left side panel). That makes 6 screws you should be looking for.



Yep, what he said!! Look under the upper surface of the bezel. You should see two in the instrument cluster section, and one each over the left side panel and over over the clock. The bezel is a tight fit pulling it out as it hits the steering column. You may want to loosen the column bolts to drop it a bit and give you more room.

Once the panel is off, there is a single screw on the left.
cgm9zBih.jpg

vc5ezB0h.jpg
 
Back
Top