I'm replacing pins on the driver's side in my 01. I wanted to confirm that my work is not done, and this pin needs to be pressed in all the way:
And how the hell do I do it? I've tried hammer and punch and it doesn't budge, and I don't want to whack it too hard to mess up the hinge. I put a 6" c -clamp in there, but it was awkward and inefficient. I'm going to try a 4" clamp today to see if I can get it in there better, but this pin feels like it doesn't want to budge! Any advice?
And how the hell do I do it? I've tried hammer and punch and it doesn't budge, and I don't want to whack it too hard to mess up the hinge. I put a 6" c -clamp in there, but it was awkward and inefficient. I'm going to try a 4" clamp today to see if I can get it in there better, but this pin feels like it doesn't want to budge! Any advice?