Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I once found a dude in I believe the north west that sold a rear stiffener for the inner rail and wrapped to the bottom as well. I can't find the site now. Anyone have a link or know if he is still making them?
I seriously doubt that's a concern after you've melted the corners into puddles mingled with the base metal, and the welds are surrounded by large amounts of undisturbed steel
I seriously doubt that's a concern after you've melted the corners into puddles mingled with the base metal, and the welds are surrounded by large amounts of undisturbed steel
Your probably right. However, square holes in a rosette weld application is about as dumb as it gets. There's a reason why you don't see square windows on an airplane. Unfortunately it took many of them to fall to the ground for engineers to see the problem.
Your probably right. However, square holes in a rosette weld application is about as dumb as it gets. There's a reason why you don't see square windows on an airplane. Unfortunately it took many of them to fall to the ground for engineers to see the problem.
or square doors/hatches on a ship (not talking about non-structural doors).........it's a lot easier for a crack to propagate from a corner than from a side....which is what a rounded off corner is
I seriously doubt that's a concern after you've melted the corners into puddles mingled with the base metal, and the welds are surrounded by large amounts of undisturbed steel