loki_racer
NAXJA Forum User
- Location
- Pittsburgh, PA
I ordered the Crown Automotive DDBXJ1 from user AOR back in Novemeber. I just now got to installing it and seem to have run in to a problem. It isn't even remotely the same shape as the stock booster.
Because of this, the booster doesn't sit flush against the firewall because it doesn't fit.
I looked at a couple other tutorials and nobody seems to mention this being an issue. Should I just bend that firewall piece out of the way? Grind it off?
It doesn't look like 4 Wheel Drive magazine had the same issue, but it's hard to tell what they did.
Any help is greatly appreciated. I've been without a Jeep, or really a car, for a couple months now.
Because of this, the booster doesn't sit flush against the firewall because it doesn't fit.
I looked at a couple other tutorials and nobody seems to mention this being an issue. Should I just bend that firewall piece out of the way? Grind it off?
It doesn't look like 4 Wheel Drive magazine had the same issue, but it's hard to tell what they did.
Any help is greatly appreciated. I've been without a Jeep, or really a car, for a couple months now.