View Single Post
  #6  
Old February 19th, 2008, 17:32
yozsef yozsef is offline
On a Time Out
 
Join Date: Feb 2008
Location: Purdue University
Posts: 1
Re: AW4 NO REVERSE OR NUETRAL

Quote:
Originally Posted by hidesintrees
check out your nss (neutral safety switch) on the rear driver side of your tranny. clean it put diaelectric grease in it and see if that does something? or test it?
thats not gonna affect anything.

NO REVERSE (D RANGES
OK)
1. Gearshift Linkage/Cable
Mis-adjusted/Damaged.
1. Repair or replace linkage parts as
needed.
2. Park Sprag Sticking. 2. Replace overdrive annulus gear.
3. Rear Band Mis-adjusted/Worn. 3. Adjust band; replace.
4. Valve Body Malfunction. 4. Remove and service valve body. Replace
valve body if any valves or valve bores are
worn or damaged.
5. Rear Servo Malfunction. 5. Remove and disassemble transmission.
Replace worn/damaged servo parts as
necessary.
6. Direct Clutch in Overdrive Worn. 6. Disassemble overdrive. Replace worn or
damaged parts.
7. Front Clutch Burnt. 7. Remove and disassemble transmission.
Replace worn, damaged clutch parts as
required.

CREEPS IN NEUTRAL
1. Gearshift Linkage Mis-adjusted. 1. Adjust linkage.
2. Rear Clutch Dragging/Warped. 2. Disassemble and repair.
3. Valve Body Malfunction. 3. Perform hydraulic pressure test to
determine cause and repair as required.
Reply With Quote