View Single Post
  #511  
Old June 10th, 2021, 15:05
89Mock 89Mock is offline
NAXJA Forum User
 
Join Date: Oct 2019
Location: Reno
Posts: 283
My jeep build with photos over the last few years.

Quote:
Originally Posted by denverd1 View Post
interesting. going hydro assist b/c I can keep mine from cracking. just bought SFR inner stiffener as well. but concerned about welding to junk sheet metal.

Curious how you go about it. going to pull my gear to tap and start welding

Get some practice material about 14 gauge in size and practice. A LOT. the unibody burns through and youíre ****ed trying to fix a hole thatís hot and thin.

When I did stiffness I was using .035 Lincoln wire and a feed rate of about 160-170 ipm.
Reply With Quote