- Location
- Newark, CA
Is there a way to fix the plastic return fitting on the back of the power steer pump reservoir?
I ham-fisted the fitting on mine and it snapped. I know I should have slit the line, got caught up in the heat of the moment since I had the feed line off and it was spilling fluid.
Basically the fitting is snapped at the reservoir side of the 90 degree fitting (the bend went with the return line). Is there an easy and reliable way to fix this or should I hit pick and pull tomorrow to locate another unit?
I ham-fisted the fitting on mine and it snapped. I know I should have slit the line, got caught up in the heat of the moment since I had the feed line off and it was spilling fluid.
Basically the fitting is snapped at the reservoir side of the 90 degree fitting (the bend went with the return line). Is there an easy and reliable way to fix this or should I hit pick and pull tomorrow to locate another unit?