- Location
- MilkyWay Galaxy
Nope, Ignition coils, at least the old style like the ones used on the XJ, are fully charged at full voltage, there is no dwell time on the coil charging side.
Did I miss part of the conversation earlier?
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
RENIX Data Logger
- Thread starter yellowoctupus
- Start date
Nope, Ignition coils, at least the old style like the ones used on the XJ, are fully charged at full voltage, there is no dwell time on the coil charging side.
Did I miss part of the conversation earlier?
etnaskynet
NAXJA Forum User
- Location
- Italy
Only a question.
The baud rate of COM port should be 9600?
Because if I'm not wrong, RENIX baud rate is 62500...
Lucio.
The baud rate of COM port should be 9600?
Because if I'm not wrong, RENIX baud rate is 62500...
Lucio.
90xj06
NAXJA Forum User
- Location
- Peabody, MA
you cant select 62500 on a com port. so the software might be doing some adjustments
etnaskynet
NAXJA Forum User
- Location
- Italy
OK, so 9600 on com port.
Another question.
Why pin no.8 (sensor ground)?
If I'm not wrong, also pin no.7 (ground) can be used instead no.8
Right?
Another question.
Why pin no.8 (sensor ground)?
If I'm not wrong, also pin no.7 (ground) can be used instead no.8
Right?
90xj06
NAXJA Forum User
- Location
- Peabody, MA
i think pin 8 grounds at the ecu. vs grounding at the battery. they both should work.
etnaskynet
NAXJA Forum User
- Location
- Italy
IT WORKS.
I'm using pin no.7 (Ignition Ground) on D2 connector instead of pin no.8 (sensor ground).
At the same time, I also connect to Ground (Ignition Ground) the cable shielding (the cable is the one used for home alarm, and has shielding).
I'll update you soon.
I've to check the reason of <5V on BATT VOLTAGE on the software.
Work in progress...
I'm using pin no.7 (Ignition Ground) on D2 connector instead of pin no.8 (sensor ground).
At the same time, I also connect to Ground (Ignition Ground) the cable shielding (the cable is the one used for home alarm, and has shielding).
I'll update you soon.
I've to check the reason of <5V on BATT VOLTAGE on the software.
Work in progress...
sorry for spamming, i solved problem.. problem was (for me) bad labeled button Save File in ViewLog app, mean start record, also, first click on "save file" that begin recording data, again click on save file or close. Better would be label on button Save File, "Start Record".
... I post here link my bad o2 sensor or air leak (o2 sensor not oscilating) and link to scheme and board in Eagle for rs232 interface
http://files.ma-elektro.eu/upload/renix_log.rar
http://files.ma-elektro.eu/upload/renix_board.rar
... I post here link my bad o2 sensor or air leak (o2 sensor not oscilating) and link to scheme and board in Eagle for rs232 interface
http://files.ma-elektro.eu/upload/renix_log.rar
http://files.ma-elektro.eu/upload/renix_board.rar
