View Single Post
  #7  
Old October 18th, 2008, 23:48
Ecomike's Avatar
Ecomike Ecomike is offline
NAXJA# 2091
 
Join Date: Dec 2006
Location: MilkyWay Galaxy
Posts: 15,350
Re: Replacing the Fuel Filter (Renix Era)

I posted the tranny mount bolt size spec here for 5-90 about 6-9 months ago. IIRC it was 12M-1.75 or 12M-2.00. I found mine missing while replacing a front drive shaft u-Joint that started out sounding like a bad rear end on sharp right turns under acceleration. The thread title is likely odd, something about rear end noise, but turned into a front DS u-joint and tranny mount bolt size discusion.

I like my gloves a little loose, or none at all, but when I use them (they come in handy when handling NaCN, HF and HNO3, and other such nice stuff) I prefer the clear polyethylene gloves. They are impervious to most anything, except a sharp knife.
__________________
Quote=8Mud: "Go ahead and put up the best fence you can build, I'll bet on some Mexican with a few dollars of nails and a pile of scrap lumber."
34 MPG , '85 2WD Cherokee Pioneer with custom installed, 64 hp, 2.2 L Nissan SD22 Diesel 5 spd Manual; & 4 Renix XJs, '87 Wagoneer 4.0, 4WD, 89-Cherokee, 4WD, '87 Cherokee 2WD, & '89 Cherokee Pioneer 2WD, all 4dr. #2091
Reply With Quote