View Single Post
  #18  
Old August 24th, 2019, 10:13
TRCM's Avatar
TRCM TRCM is offline
NAXJA Member
 
Join Date: Jan 2007
Location: Newport News,VA
Posts: 1,194
Re: Pinion shaft not clearing ring gear.

Quote:
Originally Posted by VAhasnoWAVES View Post
given your work space i would just whip out the grinder and grind the teeth until the cross shaft comes out. try to figure out which side requires less grinding and hit it with what ever tool you see fit. pack a welding blanket or something similar around the carrier. be mindful of where you are sending sparks. and clean the crap out of it with brake clean when you are done.

its pretty common practice to have to grind a tooth or two to get the cross shaft out of a stock carrier. sometimes you cant index the ring gear to the carrier in a manner that lets you pull it without grinding a tooth, but not always. dont sweat the fact that you are grinding teeth. as was already said, the major part of the contact patch is not on the area you need to grind. also, the tooth is not seeing the load from the pinion all by itself. it is always sharing the load with 2 or 3 other teeth.

definitely replace the cross shaft.

Agree with this 1000% !!




Quote:
Originally Posted by jimbar View Post
FYI some of those center pins have a machined edge cut into them allowing you to rotate it and slide it out. Have you tried to see if the pin may have a flat side to it?
If they have a machined edge, they will not work with a lunch box locker

While I don't doubt what you are saying, I haven't seen it either.
Reply With Quote