View Single Post
  #6  
Old August 29th, 2019, 19:43
Black1990jeep Black1990jeep is offline
NAXJA Forum User
 
Join Date: Apr 2018
Location: california
Posts: 351
Re: Slide in rear bumper tie ins

I too am making bumper tie ins, using 2 x 3 steel square tube, and 1 x 2 channel. Nuts strip is 1/2 inch thick bar, drilled and tapped.

I will need to knock out the exhaust hanger tab on right side to get it all to sit flat in the frame. May perhaps drill out the welds holding it.

I will get back to that after I finish my first round of front fender trim. Priorities shifting, dont want my new tires cut up on a fender lip.
Reply With Quote