View Single Post
  #3  
Old December 1st, 2016, 11:13
akendal4's Avatar
akendal4 akendal4 is offline
NAXJA Member
 
Join Date: Nov 2012
Location: Greensboro NC
Posts: 262
Re: Rear Axle options with a fron HP Ford 44.

As stated, a D44 from a waggy would be about the same with. I know they make multi-lug pattern shafts for an XJ D44 so I'd assume they make them for a waggy width as well. I know that at one point a couple different companies made C-clip eliminators for 8.8s but haven't seen any in quite some time so I don't know if they are still produced or not. I do know that if they are still made, they add some width to the axle so an explorer 8.8 may a good starting width.

Edit: Looks like Yukon still makes the Super 88 kit which is the C-clip eliminator kit. Summit has it for just under $600 and includes everything needed.
Reply With Quote