The links were in the first post, I am not sure I would recommend the electrical circuit route if you've never built this kind of stuff before. It would probably be much easier for you to use a 97 or earlier AW4 or swap the magnet wheel on the output shaft than going this route. It only takes a couple hours to swap and earlier transmissions are far more common, at least around here.
I think I may have figured out my wiring and pinouts for the 98 AW4 to go into the 97XJ... Ill add it here and whether or not you want to add to the original post is up to you,, If there is any mistakes PLEASE let me know, as I would like to fix my mistakes prior to wrecking a bunch of wiring...LOL
SO, from what i was able to source out, the 97 XJ uses 2 GREY connectors to tie the transmission to the truck (If the trans is a 97)... An 8-pin and a 6-pin..
After searching for schematics ive found that the *-pin grey connector from the JEEP side plugs right into the AW4 Trans side, BUT the colors do not match up (the functions of said wires do, but the color coding does not)... here is what ive found as follows
TRUCK SIDE (97) Trans side (98) MEANING:
PIN: PIN:
1-Violet/White 1-Green/White TRS 1-2 sense
2-Violet 2-Blue/Black TRS 3 Sense
3-Blue/White 3-Tan/White Fused ignition SW out
4-Light Green/Black 4-White TRS 4 Sense (O/D)
5-EMPTY 5-EMPTY Nothing
6-Brown/Light Green 6-Red/Black TRS Reverse Sense
7-Black/White 7-Black white Park/Neutral pos. sw
8-Black 8-Black GROUND
****COLORS DO NOT MATCH BUT THE FUNCTION DOES*****
Now, the leftover 6-PIN grey connector on the truck side does not match up to the 8-PIN Black connector whatsoever (this is where my brain started to hurt), eventually I figured out through the schematics what each wire did, and what wire went to where... Here is what I found as follows...:
TRUCK SIDE GREY 6 PIN TRANS SIDE BLACK 8-PIN MEANING
CONNECTOR CONNECTOR
PIN# PIN#
1-Black TO 6-Black OSS GROUND
3-White TO 3-Violet/white SOL A
4-Green/White TO 7-White/Brown OSS SIGNAL
5-Blue/White TO 4-White/Black SOL C
6-Orange/White TO 2-Blue/White SOL B
Pin 2 on grey connector was empty...
Pin 1 on black connector for ISS signal (NOT NEEDED FOR 97 TCU)???
Pin 5 on black connector for ISS ground (NOT NEEDED FOR 97 TCU)??
I think this is how its supposed to be wired... PLEASE let me know if this is correct... IT only makes sense that the ISS sig and ground are rendered useless in the 98 AW4 due to the fact that the 97 TCU wont read off of them anyway...?
I hope Im not way out in Left field here..... LOL:rof: