View Single Post
  #50  
Old February 16th, 2011, 22:07
Ecomike's Avatar
Ecomike Ecomike is offline
NAXJA# 2091
 
Join Date: Dec 2006
Location: MilkyWay Galaxy
Posts: 15,301
Re: Testing Jeep O2, Oxygen sensors

Quote:
Originally Posted by xjtrailrider View Post
Mike, my 12 volt supply to the O2 heater only works when the engine is running. Shouldn't have 12-14v when the key is in the running position? I have a good ground and i have a 5v supply to the O2 sensor side but my heater supply is only working when running.

1990, AW4, NP231
IIRC, mine had 12 volts in the run position, engine off, but I am not 100% sure. But mine are 87 and 89. As long as it has power with the engine running, I would not be concerned.
__________________
Quote=8Mud: "Go ahead and put up the best fence you can build, I'll bet on some Mexican with a few dollars of nails and a pile of scrap lumber."
34 MPG , '85 2WD Cherokee Pioneer with custom installed, 64 hp, 2.2 L Nissan SD22 Diesel 5 spd Manual; & 4 Renix XJs, '87 Wagoneer 4.0, 4WD, 89-Cherokee, 4WD, '87 Cherokee 2WD, & '89 Cherokee Pioneer 2WD, all 4dr. #2091
Reply With Quote