ptimhere
NAXJA Forum User
- Location
- new london, ohio
So my son's jeep has been through quite the load of work the past 10 days. But today became a problem. After replacing all the brake rotors, pads, and the rear calipers (it has a zj disc conversion), the jeep started, pulled out of the garage, then shut off.
When we tried to start it again, it would not start and we get a "no bus" on the dash.
Just as a side note, we replaced the heater core last weekend and so many things were unplugged. But, it has been driven back and forth this week to school. My son said the only thing that was a problem was the radio (which appears to be a loose connection behind the radio after the dash re-install).
There were no signs of any other problems and no check engine lights.
I tried to use my scan tool, but it is not working.
I used the key technique to check for any engine codes and there were none.
Any suggestions?
When we tried to start it again, it would not start and we get a "no bus" on the dash.
Just as a side note, we replaced the heater core last weekend and so many things were unplugged. But, it has been driven back and forth this week to school. My son said the only thing that was a problem was the radio (which appears to be a loose connection behind the radio after the dash re-install).
There were no signs of any other problems and no check engine lights.
I tried to use my scan tool, but it is not working.
I used the key technique to check for any engine codes and there were none.
Any suggestions?