View Single Post
  #1  
Old July 2nd, 2007, 09:12
Vince's Avatar
Vince Vince is offline
NAXJA Member
 
Join Date: Jan 2006
Location: Wales
Posts: 1,094
Swapping early NP242 for a late NP242

My front shaft bearing on my 1993 NP242 needs replacing and I opted to swap out the transfercase with another from a junkyard. The replacement 242 was purchased over the phone with a short warranty and arrived today. The 'new' 242 looks in good condition but has one major difference to the one already in my Jeep, the tailcone is the later design with the seal on the shaft instead of on the yoke.

Can I use my existing rear driveshaft and slip yoke with this transfercase? I am assuming all I need to get is the rubber bellows that goes over the shaft and yoke? Or do I need a slip yoke to match this transfercase as well?
Reply With Quote